20
Procedure:
Enter
<P2.rEAd / 2.4.Aut>
submenu.
Press
key, parameter values are displayed successively one by one:
YES
– autozero function enabled,
no
– autozero function disabled.
Press
key to confirm, next go to the home screen.
13.5. Tare Function
'Tare' function has been designed to enable setup of appropriate parameters
for tare operation.
Procedure:
Enter
<P2.rEAd / 2.5.tArE>
submenu.
Press
key, available values are displayed successively one by one:
no
Regular tare mode. Select this parameter to make the scale overwrite
the set (selected) tare value with the most recently entered one.
tArF
Select this parameter to make the scale store the latest tare value
in memory. The latest tare value is displayed after scale restart.
AtAr
Automatic tare mode.
EAcH
Select this parameter to make the scale automatically tare each accepted
measurement.
Press
key to confirm, next go to the home screen.
13.6. Tare: Enter Mode
The tare is entered using
+
keys combination from the home screen
level. There are two enter modes.
Procedure:
Enter
<P2.rEAd / 2.6.ttr>
submenu.
Press
key, parameter values are displayed successively one by one:
