b)
Password:
To re-define the password (Default =
[Enter]
), key in the new password (up to 8 characters)
and press
[Enter]
. The password can include blank
spaces and higher order ASCII characters. Note that
the Backspace key will not function during password
definition.
c)
Default (Power-Up Default):
Allows the user to
define default On/Off conditions for each switched
plug as described in Section 4.1. Key in the desired
Power-Up Defaults and press
[Enter]
.
d)
Echo Mode:
When Echo Mode is enabled, commands
sent to the RPB+ will be echoed back to your PC or
terminal, allowing keyboard entries to be displayed by
your communications program. To enable or disable
the Echo Mode, type
Y
or
N
, press
[Enter]
, then
continue with the parameter definition routine. When
the “RPB+>” prompt returns, type
/D
[Enter]
.
Notes:
·
The Echo Mode will not be enabled / disabled until
the /D command is invoked.
·
If the Default String includes invalid or missing
characters, the /D command will not function.
e)
Plug Labels:
Allows the user to identify the device
connected to each plug (e.g. "
SERVER
"). Key in the
desired name (up to 16 characters) and press
[Enter]
.
Page 7
Start-Up / Configuration
Location:
WESTERN TELEMATIC, INC.
Default:
01110
Plug
Label
Condition
1
PRINTER
OFF
2
SERVER ONE
ON
3
SERVER TWO
ON
4
MODEM BANK
ON
5
FAX
OFF
Command Summary:
/S
Status
/P
Enter Parameters
/D
Set Plugs to Default
/X
Exit
To Switch /n s
Where n = Plug #, * = All, and s = ON/OFF/BOOT
RPB+>
Figure 5: The Status Screen
