/W
Display Port Parameters (Who)
Displays configuration of an individual port, but does not allow the user to change parameters.
Ports with User Level command capability cannot display parameters for other ports.
Normally, the Port Parameters screen will not include the Port Password. Note however, that
when the Supervisor Mode is active, the /WP option can be used to display the password for
the target port. For more information, please refer to Section 6.3.
Availability:
Supervisor / User
Format:
/W[P] [x]
[Enter]
Where:
P
When the “
P
” option is included (e.g.
/WP 5
), the Port Parameters screen will list
the password for the port, if defined. (Supervisor Mode Only).
x
Port number or name. If the "
x
" argument is omitted, parameters for your resident
port will be displayed.
Response:
Displays port parameters.
Example:
To display parameters for a port named "SERVER", access the Command Mode
from a port with Supervisor Level command capability, and type
/W SERVER
[Enter]
.
/X
Exit Command Mode
Exits Command Mode. When issued at the Net Port, also ends the telnet session. Note that
exiting from Command Mode will not terminate port connections.
·
Any-to-Any Mode:
Exits Command Mode.
·
Modem Mode:
Disconnects and resets modem, hang-up message is sent, hardware line to
modem drops for 500 ms, and modem reset string is sent.
Availability:
Supervisor / User
Format:
/X
[Enter]
Response:
Disconnected
9-9
APS Series - Asynchronous Port Switches, User's Guide
Command Reference Guide
