button, wait for the Port LEDs to flash, and then release the SET button.
Note:
During initialization, all port LEDs will flash ON three times.
●
During initialization, all command-selected parameters will be cleared, and the
CMS will revert to the default parameters specified by the Option Switches.
●
RDY: (Ready) Flashes to indicate unit is operational.
4.
NET: Lights when a Network Connection is present.
5.
ACTIVITY LEDs: Light to indicate data activity at the corresponding port. The CMS-16
includes sixteen Activity LEDs, and the CMS-8 includes eight Activity LEDs.
6.
2.2. Back Panel
Figure 2.2: Instrument Back Panel
Network Port: An RJ45 Ethernet port for connection to your TCP/IP network. To
communicate via network, you must first specify the IP Address, Subnet Mask, and
Gateway Address as described in
Section 5.5.4
.
1.
Power Cable Receptacle
2.
Power Switch
3.
RS232 PORTS: For connection to console ports on target devices. Standard DB9
connectors configured as DTE ports. The RS232 ports are similar to a serial port on a PC.
When connecting a modem, use a standard serial cable. When connecting a PC or other
DTE device use a null modem cable.
4.
