17-8
Command Reference Guide
17.3.2. Control Commands
/X
Exit Command Mode
Exits command mode. When issued at the Network Port, also ends the Telnet session.
Note:
If the /X command is invoked from within a configuration menu, recently
defined parameters may not be saved. In order to make certain that parameters
are saved, always press the
[Esc]
key to exit from all configuration menus and
then wait until "Saving Configuration" message has been displayed and the
cursor has returned to the command prompt before issuing the /X command.
Availability:
Administrator, SuperUser, User, ViewOnly
Format:
/X
[Enter]
/C
Connect to Serial Port
When the RJ-45 SetUp Port has been configured as a Normal Mode Port as described in
Section 6.7, the /C command can be used to create a connection between the Network
port and the serial SetUp Port.
Notes:
• User level accounts can only connect to the SetUp Port when serial port
access is specifically permitted by the account.
• To terminate a port connection, either type
^X
(
[Ctrl]
plus
[X]
) or invoke the
currently defined disconnect sequence.
Availability:
Administrator, SuperUser, User
Format:
/C 1
[Enter]
