5.3. PLS Command/Menu Conventions
When invoking PLS commands or selecting items from
configuration menus, note the following:
·
All PLS commands can be invoked at the PLS> command
prompt, or from the General Parameters Menu, Circuit
Parameters Menus, Monitor Parameters Menu, or Network
Parameters Menu.
·
PLS commands are not case sensitive.
·
All PLS commands are invoked by pressing
[Enter]
.
·
To select an item from a PLS menu, key in the number for
the item and press
[Enter]
. To exit from a menu, press
[Esc]
at any time. Parameters defined up to that point will
be saved.
·
To display the Help Screen, type
/H
[Enter]
.
·
The "
,y
" option can temporarily suppress the "Sure"
(confirmation) prompt. The "
,y
" option is entered at the
end of the command line, immediately following the
command or argument. For example, to reset the network
port without displaying the "Sure" prompt, type
/T,y
and
then press
[Enter]
.
·
If you are configuring the PLS via network, network
communication parameters will not be changed until your
telnet connection to the PLS has been terminated
5-4
PLS-345 - Physical Layer Switch; User's Guide
Summary of Contents for PLS-345
