10. Command Summary
All PLS-345 commands conform to the following standards:
·
All commands normally begin with the "
/
" (foreword slash)
character. If you wish to temporarily suppress command
echo, use the "\" (
backward
slash) character instead of a
forward slash.
·
All command lines are invoked by pressing the
[Enter]
key.
·
Both the System Level Password and User Level Password
are case sensitive.
10.1. Display Commands
These commands are used to display the help screen, circuit
status and network status.
/H
Display Help Screen
Displays a Help Screen (Figure 3.2), which lists all available
commands, along with a brief description of each command.
Command Format:
/H
[Enter]
Response:
Displays Command Help Screen, followed by the
PLS> command prompt.
Command Availability:
System and User.
/S
Display Circuit Status
Displays a status screen (Figure 3.1), which lists the currently
selected A/B line for each of the three circuits, and the selected
values for features such as the Command Echo and Inactivity
Timeout.
Command Format:
/S
[Enter]
Response:
Displays Circuit Status Screen, followed by the PLS>
command prompt.
Command Availability:
System and User.
10-1
Summary of Contents for PLS-345
