/D
Set Circuits to Default
Switches all PLS-345 circuits to their default A/B state. Note
that the default A/B state is set using the Circuit Parameters
Menu, as described in Section 7.2.2.
Command Format:
/D
[Enter]
Command Arguments:
,y
Suppress Confirmation (Sure) Prompt. For example,
"
/D,y
" switches all circuits to their default states
without
displaying the confirmation prompt.
Response:
Displays message indicating that circuits will be set
to defaults, waits for user confirmation (unless suppressed),
switches all circuits to user-defined default positions, and then
displays Status Screen.
Command Availability:
System and User.
/T
Reset Network Interface
Terminates the Telnet connection and then resets the network
interface.
Note:
In order to prevent remote users from being
"locked out" of command mode, the /T command
cannot be invoked via the Network Port. The
Network Port is not allowed to reset itself.
Command Format:
/T
[Enter]
Command Arguments:
,y
Suppress Confirmation (Sure) Prompt. For example,
"
/T,y
" resets the Network Port
without
displaying the
confirmation prompt.
Response:
Displays message indicating that network port will
be reset, waits for user confirmation (unless suppressed) and
then resets network port.
Command Availability:
System and User
10-5
Section 10: Command Summary
Summary of Contents for PLS-345
