7.
SNMP Management:
The network manager that will
receive SNMP Traps generated by this alarm. This item
selects one, both or none of the two available SNMP
Managers. IP Addresses for these SNMP Managers are
defined via the Network Port Configuration Menu.
8.
Output Contacts:
Defines the open/close operation that
will be performed by the optional Output Contacts when
this alarm generates an Output Contact action. An "O"
indicates the contact will be opened, "C" indicates the
contact will be closed, and a dash (-) indicates that the
status of the contact will not be changed.
9.
Message:
The message sent when a Callout, Alphanumeric
Page, SNMP Trap or Console action is generated.
10.
Auto Execute:
If enabled, NetLink will execute the
command string defined under item 11 when a Callout or
Console action is generated by this alarm.
11.
Execute Commands:
The Auto-Execute command string.
This command string consists of a series of ^Bxx commands
with each command separated by a backslash and forward
slash character (e.g.
\/03\/01
). ^Bxx commands are
discussed further in Section 18. For more information,
please refer to the example in Section 12.3. (Up to 64
characters;
Default = undefined
).
Note:
In order for Auto Execute to function, item
10 must be enabled, the command string must be
defined, and either a Callout or Console action must
be selected.
10-2
PollCat NetLink User's Guide
80% FULL ALARM:
1.
80% Full Alarm:
Off
2.
Action:
None
3.
Phone #:
(undefined)
4.
Pager ID 1:
(undefined)
5.
Pager ID 2:
(undefined)
6.
Pager ID 3:
(undefined)
7.
SNMP Mgmt:
Manager #1
8.
Output Contacts
1/2/3/4:
-/-/-/-
9.
Message:
(undefined)
10. Auto Execute:
Off
11. Execute Cmds:
(undefined)
(Cont.)
Enter Selection,
Press <ESC> to return to previous menu ...
Figure 10.1: 80% Full Alarm Configuration Menu
Summary of Contents for PollCat NetLink
