12.2.6. Output Contact
If the "Output Contact" action is selected, NetLink can open or
close the optional Output Contacts when an alarm is generated.
Note:
In order to use the Output Contact action, the
Idle/Non-Alarm state for each contact should first be
defined as described in Section 11.
When the Output Contact action is selected, the following item
must be defined at the configuration menu for the specified alarm.
·
Output Contacts:
Specify the target Open/Closed/No Change
action for each Output Contact. When an alarm is generated,
the Output Contacts will be opened or closed as specified.
12.2.7. Console
If this action is selected, NetLink will send a message out the
Console Port when an alarm is generated. Typically, this message
describes the type of alarm event that occurred. NetLink can also
execute a user-defined command string to report status or
download data.
Note:
In order to use the Console action, Console
Port communication parameters must first be
properly defined as described in Section 4.4.3.
When the Console action is selected, the following items should be
defined at the configuration menu for the specified alarm.
·
Message:
(Optional) Enter a message to describe the type of
alarm event that occurred; for example "80% FULL".
·
Auto-Execute:
(Optional) Enable or disable the Auto-execute
function and then define the command string at the "Execute
Commands" prompt. Auto Execute command strings are
discussed further in Section 12.3.
12-5
Alarm Actions
Summary of Contents for PollCat NetLink
