Operation
pH 3310
52
ba75802d06
05/2017
4.6
Transmitting data (USB interface)
4.6.1
Options for data transmission
Via the USB interface you can transmit data to a PC. The following
table shows which data are transmitted to the interface in which way:
Note
The following rule applies: With the exception of the menus, shortly
pressing the
<F2>
/
[USB output]
key generally outputs the display con-
tents to the interface (displayed measured values, measurement data-
sets, calibration records).
Data
Control
Operation / description
Current
measured values
of all connected
sensors
Manual
With
<F2>
/
[USB output]
.
Simultaneously with every
manual storage process
(see section 4.5.1).
Automatic, at
intervals
With
<F2
_
>
/
[USB output]
.
Then you can set the trans-
mission interval.
Note:
For operation with MultiLab
pilot: set the
Send ID
option
to
No
Simultaneously with every
automatic storage process
(see section 4.5.2).
Stored measured
values
Manual
Displayed dataset with
<F2>
/
[USB output]
after
calling up from the memory.
All datasets with the
Output
to USB
function.
For details, see section 4.5.3.
Calibration
records
Manual
Calibration record with
<F2>
/
[USB output]
.
For details, see section 4.6.
Automatic
At the end of a calibration
procedure.
