Wuhan Guide GUIDE EasIR-9, User Manual

User Manual

17 

y

Select “

Sleep

” by pressing “

↑

” and “

↓

”, and “OK” to confirm. 

y

Press button 

to make Sleep mode enabled 

y

Press button          and 

  to decrease/increase the time of sleep mode, sleep time is displayed at the 

bottom of LCD. Press 

  to save and confirm. Machine auto enter sleep mode after pre-set timing value, 

press any button activates the machine from sleeping mode. 

y

Press T button return to real time IR mode. 

y

Adding Voice Annotation to Saved Data       

Voice annotation can only be added to an image prior to storing it. After capturing an image, the Image Capture menu 

appears. To add a voice annotation to the image: 

y

Press the “Voice”. 

y

Press “Record” to start the recording. 

y

Speak into the Imager’s microphone opening. When done recording, press the softkey labeled “Stop”. Up to 60 

seconds of voice annotation can be recorded for each image. Once it reaches 60 seconds, recording will stop 

automatically. 

y

Press “Play” to replay the voice annotation before saving. 

y

Press “Save” to save the voice

annotation. 

Listening to Voice Annotation 

To play the voice annotation already stored with an image on the UFlash or SD card: 

y

Perform the steps in the “Reviewing and Deleting Stored Images” section to bring the desired image to the 

EASIR-9

’

s display. 

y

Press the “Voice”. 

y

Press the “Play”. 

The saved voice annotation will be replayed through the imager’s speaker. 

Changing the Temperature Units 

The EASIR-9 will display temperature in Fahrenheit or Celsius. To change the temperature units: 

y

Press 

  to display the main menu. 

y

Press the “Setup” 

y

  Select “Tunit” by pressing “

↑

” and “

↓

”, and “OK” to confirm. 

y

Press

  for Celsius or 

 for Fahrenheit. 

Doing spot analysis 

EASIR-9 supports single spot measurement. The location of center spot can be adjusted in live image: