FLEXCOMM
II
C-5000 (Non-Digital)
Installation Manual
150-1355-000 Rev. M
CONFIDENTIAL AND PROPRIETARY TO COBHAM
Page 44
(3) “N” Connectors
Stop 1
Strip cable jacket, braid, and dielectric to
dimensions shown. All cuts are to be
sharp and square.
Important-
Do not
nick braid, dielectric, and center
conductor. Tinning of center conductor is
not necessary if contact is to be crimped.
For solder method, tin center conductor
avoiding excessive heat.
Step 2
Slide outer ferrule onto cable as shown.
Flare slightly end of cable braid as shown
to facilitate insertion of inner ferrule.
Important:
Do not comb out braid. Place
contact on cable center conductor so it
butts against cable dielectric. Center
conductor should be visible through
inspection hole in contact, Crimp or
solder contact in place.
Step 3
Install cable assembly into body
assembly so inner ferrule portion slides
under braid. Push cable assembly
forward until contact snaps into place in
insulator. Slide outer ferrule over braid
and up against connector body. Crimp
outer ferrule.
Wulfsberg P/N
Straight
Right Angle
a =
b =
c =
129-049112-01
X
.687(17.4) .281(7.1) .187(4.7)
129-049113-01
X
.687(17.4) .281(7.1) .187(4.7)