FVB120-PAT
Product information
FVB120-PAT_V3.30_PI_2018-01_EN Subject
to technical changes
Page 3 of 4
Circuit diagram
Notes!
The CAN bus shield must be connected at only one (!) CAN bus end by means of the
6.3mm connecting lug with PE.
Further information on the CAN bus can be found in the FRIGOLINK bus system
manual.
Installing
WARNING! Danger to life from electric shock and/or fire!
Switch off the power to the entire plant before installing! Otherwise a mains voltage
and/or external voltage may still be present even if the control voltage is switched off!
Always remove both power plugs (230V~ and N)!
53
106
90
58
This device is designed for top-hat rail
installation. The housing is of a standard size
and is also suitable for installation in fuse boxes,
distribution switch boxes or electric boxes of
refrigeration units.
The devices can be positioned immediately next
to one another and without gaps.
Place the device with the upper guide edge on
the top-hat rail.
Then press the device gently downward until it
engages with the fastening safety catch on the
top-hat rail.
