9
Operation
(See Fig. III)
1
Potentiometer
2
ON/OFF rocker switch
The WGL 1 lamp can be controlled using the two
rocker switches
[2]
and the rotary controller on the
control unit.
The control unit is integrated in the power supply
cable.
2 of the 4 Xpect 2 LED modules are connected to
each of the rocker switches.
Clockwise rotation of the potentiometer
[1]
increases the illuminance (illumination level), while
anticlockwise rotation reduces it.
Maintenance / care
Attention!
Clean the device only when the mains
plug has been removed.
A damaged lead may only be ex
-
changed by the manufacturer
or an authorised service company.
■
Clean the lamp with hot water, or if necessary
with a standard detergent. Do not use any tech-
nical solvents, acetone, benzene, tetrachloro-
methane, etc.
■
Likewise, do not leave in contact with oils or
grease for long periods.
LED
!
100%
< 100%
+
EN 12464
+
WÜRTH
Explanation of pictograms
Lamps with limited surface temperature
dust-tight
water-jet proof
Protection class I
Compliance with EU directives
Electronic scrap (WEEE directive)
Spare parts
If in spite of careful manufacturing and test pro-
cedures, the device becomes faulty, a repair by
Würth masterService should be arranged. With any
enquiries or spare parts orders, always quote the
item number as given on the device type plate.
Warranty
We provide a warranty for this Würth device from
the date of purchase and in accordance with the
legal/country-specific regulations (proof of purchase
through invoice or delivery note).
Damage that has occurred will be corrected either
by replacement or by repair. Damage caused by
improper handling is not covered by the warranty.
Claims can only be acknowledged, if the device
is transferred fully non-disassembled to a Würth
agency, your Würth sales representative or a Würth
authorized customer service office. Subject to techni
-
cal changes without prior notice.
We accept no liability for printing errors.
Environmental instructions
Do not dispose of this device with
household waste. Dispose of the
device via an approved waste
disposal company or via your local
authority waste disposal facility.
Observe the currently valid regula-
tions. In case of doubt, contact your
waste disposal facility. Dispose of all
packaging in an environmentally compatible
manner.
