16
The lithium ion battery can be charged at any time without reducing its service life.
Interrupting the charging procedure does not damage the battery.
The lithium ion battery is protected against deep discharging by the “Electronic Cell
Protection (ECP)”. When the battery is empty, the cordless worklight is switched off
by means of a protective circuit.
Do not continue to press the On/Off switch after the cordless
worklight has been automatically switched off.
The battery can be
damaged.
To remove the battery
3
, press the battery unlocking button
4
and pull the battery
out of the cordless worklight toward the rear.
Do not exert any force.
The battery is equipped with a NTC temperature control which allows charging only
within a temperature range of between 0 °C and 45 °C. A long battery service
life is achieved in this manner.
Observe the notes for disposal.
Starting Operation
Inserting the battery
Use only original Würth Lithium-Ion batteries with the voltage
listed on the nameplate of your power tool.
Using other batteries can
lead to injuries and pose a fire hazard.
Insert the charged battery
3
into the handle until it can be felt to engage and faces
flush against the handle.
Switching On and Off
The cordless worklight produces a light beam that emerges from
the lamp head 1.
To
start
the cordless worklight, press the On/Off switch
2
.
To
switch off
the cordless worklight, press the On/Off switch
2
again.
To save energy, only switch the cordless worklight on when using it.
OBJ_BUCH-1029-003.book Page 16 Tuesday, September 17, 2013 6:22 PM