20
Adjusting the penetration depth
(Fig. IV)
The nail penetration depth can be set using the
depth adjustment wheel
[5]
.
■
Turn the depth adjustment wheel to the
left to reduce the nail penetration depth.
■
Turn the depth adjustment wheel to the
right to increase the nail penetration
depth.
Belt hook (Fig. V)
The belt hook
[8]
can easily be positioned on the
left or right side of the device, to suit left or right-
handed users.
If it is not being used, it can be turned towards the
front or back on the bottom part of the grip.
Operation
Safety interlock (Fig. II)
The device is equipped with a safety interlock
[9]
.
■
Push the safety interlock
[9]
to the right to
prevent triggering.
3
The trigger is locked and the power is diverted
to the motor.
3
The device becomes fully functional once the
safety interlock
is pushed to the left.
WARNING !
Risk of severe injuries.
Â
Unintentional starting can result
in injuries.
¾
Switch off the device and remove
the battery before any adjustment
or any removal/fitting of
accessories.
WARNING !
Risk of severe injuries.
¾
Always hold the device firmly
and be prepared for any sudden
reaction.
Preparing the device for use
■
Remove the battery
[11]
from the device
and check that the safety interlock has been
activated.
■
Remove all nails from the magazine
[2]
.
■
Check that the contact stop
[3]
moves freely.
■
Insert a nail strip into the magazine.
■
Reinsert the battery
WARNING !
Risk of severe injuries.
¾
Do not use the device if the
contact stop or the cocking slide
cannot move freely.
Nailing (Fig. VI)
WARNING !
Injuries or material damage due to
unintentional triggering.
Â
Unintentional firing could be trig
-
gered and cause severe injuries.
¾
Do not hold the trigger pressed
down, if the device is not being
used.
¾
Leave the safety interlock in
the locked position to prevent
unintended activation.
■
Place the device perpendicular to the material
surface. The non-mar tip and the base of the
magazine must make firm contact with the
surface.
■
Press the contact stop against the material
surface.
3
The device safety mechanism is deactivated, the
motor starts.
■
Press the trigger to fire the nail into the material.
Attention !
If you are using this device on materials, that
you do not want to damage, e.g. visible wooden
facing boards, use the supplied plastic protective
cap over the contact stop.
