14
Close the cover
16
.
When inserting the gas cartridge, small
quantities of combustible gas can escape. Do
not inhale the gas, do not smoke and keep
clear from open flames or sparks.
If gas is still detectable after inserting the gas
cartridge, remove the gas cartridge immedi-
ately and check the cause.
Loading the Magazine
– Insert the magazine strip as shown.
– Pull the tensioning slider
6
completely to the rear
and guide it back again until it faces against the
magazine strip.
– To remove the magazine strip, pull the tensioning
slider a little toward the rear. Actuate the release
lever
5
and guide the tensioning slider
6
back.
Actuate the retaining spring
21
and pull out the
magazine strip.
Structural Materials and
Clearances
Fastening bolts may not be driven into unsui-
table materials or building components.
Recommended Structural Material
Check the thickness of the structural material. The
minimum required penetration depth of the faste-
ning bolts and the minimum strength of the structural
material must be given in order to reach secure fas-
tening of the attachment.
Minimum clearances and edge distances of
structural materials (according to § 18 BGV D9)
The distance from the shooting location to any free
edge must be large enough, to avoid sideward ex-
pulsion of the fastening bolt.
The fastening bolts must be driven-in with such clea-
rance to each other, that expulsion at the shooting
location due to breaking out or rupturing of the
material is avoided.
Operating Instructions
Setting Bolts/Nails
1. Hold the tool firmly with both hands and ensure
secure footing.
2. Position the tool in a right angle to the surface of
the structural material. The neck-down sleeve
4
and the magazine base
10
must be seated secu-
rely.
3. Press the tool via the neck-down sleeve against
the surface of the structural material. This releases
the safety of the tool, the blower motor is switched
on and draws in air.
20
19
16
5
21
Structural
material
Penetration
depths
Minimum
thickness
Concrete (DIN
1045, B10 - B55) 15–32 mm
120 mm
Lime-sand brick
ca. 40 mm
100 mm
Steel
ab 6 mm
ab 6 mm
Solid brickwork
15–32 mm
100 mm
Brickwork Concrete,
reinforce
concrete
Steel
Distance to the
free edge
5 cm
5 cm
3-times
the bolt
shaft Ø
Clearance bet-
ween the faste-
ning bolts
10-times
the bolt
shaft Ø
10-times
the bolt
shaft Ø
5-times
the bolt
shaft Ø
DIGA CSM-1.book Seite 14 Freitag, 15. August 2008 1:20 13
