17
Storage
Always remove the battery and the gas cart-
ridge from the tool after finishing work, be-
fore longer work breaks, for transport and
storage maintenance, before troubleshooting
and before replacing wear parts.
Keep the tool and the battery stowed in the original
tool case at a secure, dry and heat-protected loca-
tion. Always store gas cartridges separately and
protected.
Unauthorized persons, especially children, may not
have access to the tool or the gas cartridges.
Accessories
Due to the continuous new development of fastening
material, it is possible that not all fastening
bolts/nails are illustrated. Please refer to your Würth
customer advisory service or select from the latest
catalogue.
Guarantee
For this Würth machine, we provide a guarantee in
accordance with statutory/country-specific regulati-
ons from the date of purchase (proof of purchase by
invoice or delivery note). Damage that has occurred
will be corrected by replacement or repair.
Damage caused by normal wear, overloading or
improper handling is excluded from the guarantee.
Claims can only be accepted if the power tool is sent
undisassembled to a Würth branch office, your
Würth sales representative or a customer service
agent for Würth compressed-air and power tools.
Disposal
Power tools, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into
household waste!
According to the European Directive
2002/96/EC on waste electrical
and electronic equipment and its in-
corporation into national law, power tools that are
no longer suitable for use must be separately collec-
ted and sent for recovery in an environmental-fri-
endly manner.
Noise/Vibration Information
Measured values determined according to
EN 12 549.
Typically the A-weighted noise levels of the product
are: sound pressure level: 105.06 dB (A)
sound po-
wer level: 113.16 dB (A).
Wear ear protection
!
The typical weighted acceleration is 3.7 m/s
2
.
Declaration of Conformity
We declare under our sole responsibility that this
product is in conformity with the following standards
or standardization documents: EN 292-1/-2,
EN 349, EN 563, EN 614-1, prEN 792-13,
EN 12 096, EN 12 549:1999, EN 50 081-1,
EN 50 082-1, EN 50 144-1, EN 55 022,
EN 60 335-1, EN 60 335-2-29, EN 60 555-2/-3,
EN 60 950:2000, EN 61 000-3-2, EN 61 000-3-3,
EN 61 204-3, EN ISO 4871, EN ISO 11 688-1,
EN ISO 11 690-1, ISO 8662-11,
ISO 8662-11:1999, IEC 1000-4-2/-3/-4 according
to the provisions of the regulations 73/23/EWG,
89/336/EWG, 89/392/EWG, 98/37/EWG
08
Adolf Würth GmbH & Co. KG
P. Zürn
A. Kräutle
1x +
1000x
l
[mm]
Art.-Nº.
20–65
0864 940 0..
0864 940 1..
Subject to change without notice
DIGA CSM-1.book Seite 17 Freitag, 15. August 2008 1:20 13
