14
①
Transport: The machine moves without working.
②
Normal: The machine is in normal working mode.
③
Packed Snow: The machine works on thick or solid snow field.
NOTE: To regulate the function shifts, the handle should be pressed down to lift the front end of the
machine a bit up away from the ground so that the function shift regulation handle will not become bent.
STARTING
1. Start the engine as above. Let the engine run a few minutes to warm before use.
2. Set the chute deflector.
3. Turn the adjustment lever and set the deflector to throw the snow in the direction of the wind.
The gear stick must not be moved if the driving clutch lever is depressed.
4. Set the gear lever to a suitable position.
5. Press down the auger clutch lever to activate the auger and discharge fan.
Watch out for rotating auger. Keep hands, feet, hair and loose clothing away from any moving
parts on the machine.
6. Press down the auger clutch lever. The snow thrower now moves forward or backwards depending on the
gear you have chosen.
5.8 DRIVING TIPS
The silencer and surrounding parts become very hot when the engine is running. Risk of burns.
1. Always run the engine on full throttle or next best.
2. Always adapt the speed to the snowy conditions. Regulate the speed with the gear stick.
3. Snow is more effectively removed directly after falling.
4. Always throw the snow in the direction of the wind if possible.
5. Adjust the shoes with the screws (1:H) to suit the ground conditions:
- On flat ground, e.g. asphalt, the shoes should be about 3mm under the scraping blade.
- On uneven ground, e.g. gravel paths, the shoes should be about 30mm under the scraping blade.
