14
(Figure 3)
4 Mount the rocker:
A. For STG5556 (6562) (See Figure 5), pass the rocker (12) through the rocker base (7) as shown in
Figure3, and pass the pin (13) through the rocker (12) so that it is coupled to gear shaft;
B. For other machine models (see Figure 3), pass the rocker (14) through the rocker base (11) as shown in
Figure4, and pass the pin (15) through the rocker (11) so that it is coupled to the universal joint;
(Figure 5) (Figure 6)
5. Install the chute: Place the chute plastic ring (16) below the chute (17) and locate it onto the chute base
(18) on the housing (see Figure 7); connect and tighten up the chute presser (19) plus two chute washers
(20) with hexagon nipples (21), M6 washers (22), and M6 lock nuts (23) (see Figure 8).
6 5
4
13 12
7
(Figure 4)
10 9 8
11
14
15
11
