15
DMX Setup and Operation
Controls and Indicators
Nexera has controls and indicators as follows:
A three character seven-segment display
4 push buttons:
Menu
, (
+
), (
-
), and
Enter
Power (red) and signal (green) indicator LED’s
The seven-segment display shows the channel number (c01 – c46) and the speed mode
(hi S – lo S). It also displays any error messages, which will be covered in a later section.
The
Menu
button allows you to switch between channel and mode select. Pressing the
Select button saves the current channel or mode setting before switching.
The (
+
) button allows you to increment Nexera’s RAM channel when in channel mode, or
toggle between high and low speed in speed mode. Changes are recorded in non-
volatile memory immediately, and display flashes for 10 seconds to indicate that a
change has been made.
The (
-
) button allows you to decrement Nexera’s RAM channel when in channel mode, or
toggle between high and low speed in speed mode. Changes are recorded in non-
volatile memory immediately, and display flashes for 10 seconds to indicate that a
change has been made.
The
Enter
button stops the display from flashing after changing the channel or speed.
The red power indicator LED remains lit as long as there is power at the PC board.
The green LED flashes when a signal is present. It turns off 60 seconds after the last
button press.
The ISP programming port allows the user to reprogram the unit as new software
revisions become available without having to disassemble the unit. See ‘Reprogramming
via the ISP port’ in the Service section of the manual for instructions on upgrading Nexera
software.
Summary of Contents for NEXERA 2560
Page 1: ...Color Mixing Luminaire ...
