19
Cleaning the Color Module
Remove the color module from the front barrel by removing four screws indicated in
the figure.
Use a DMX source and a RAM Power Supply to
command all color filters to 0% DMX.
Using the DMX source command the magenta
filter up into the color module aperture so the top
of the filter is at the top of the aperture.
Clean the exposed filter surfaces with a clean
cloth and alcohol.
Command the magenta filter higher to expose
more of the filter, and clean with alcohol.
After the entire magenta filter has been cleaned,
command it back to 0% and repeat for the
remaining color filters.
Install the color module in the front barrel with the
XLR connectors facing the rear of the unit.
Replace the four mounting screws.
Cleaning the Lenses
Remove the color module from the front barrel by removing four screws indicated in
the figure in the ‘Cleaning the Color Module’ section above. Set the color module
aside.
Separate the front and rear barrel halves by
removing the four screws from the front barrel
as indicated in the picture. Set the rear barrel
aside.
Remove the Fresnel lens screw and washers.
Back the Fresnel knob 90% out, then using the
knob tilt the Fresnel lens out toward the front of
the fixture.
Grasp the edge of the Fresnel lens and back the knob the rest of the way out.
Tilt the Fresnel lens between the accessory brackets and remove the lens. The
accessory brackets can be removed
to ease extraction of the Fresnel lens.
Use clean pressurized air to remove
dust from the lenses
.
Clean the condenser and Fresnel lens
with a soft cloth and an ammonia
based cleaner.
Reinstall the Fresnel lens by tilting
lens back into position in the barrel.
Start the Fresnel lens washers and
screw while holding the lens in
alignment with the range slot.
Start the Fresnel knob, then tighten the Fresnel screw, and finally tighten the knob.
Mate the front and back barrels and secure with four screws.
Summary of Contents for NEXERA 2560
Page 1: ...Color Mixing Luminaire ...
