4
To protect yourself and others from electric shock:
•
If the Nexera fixture was received without an AC cord plug attached, attach the
appropriate lamp cord plug according to the following code:
green – ground/earth
gray – neutral
gray – line
•
Disconnect the fixture from AC power before removing or installing the lamp, fuses, or
any electronic parts.
•
Always ground (earth) the fixture electrically.
•
Use a good source of AC power that complies with local building and electrical codes and
has both overload and ground fault protection.
•
Nexera fixtures and RAM Power Supplies are suitable for dry locations only. Do not
expose the fixture or power supply to rain or moisture.
•
Refer all service to a Wybron certified service technician.
To protect yourself and others from burns and fire:
•
Do not operate the fixture with missing or damaged lenses or reflector.
•
When replacing the lamp, allow the fixture to cool for at least 5 minutes before removing
the lamp holder from the fixture.
•
Do not stare directly into the light. Never look at an exposed lamp while it is illuminated.
•
Replace the lamp if it becomes damaged or thermally deformed.
•
A hot lamp may be an explosion hazard. Do not open the fixture for 5 minutes after power
has been disconnected. Wear eye and hand protection when re-lamping.
•
Do not use any lamps other than those approved for use by Wybron and listed in this
manual. Use of any other lamp may be hazardous and may void the warranty.
•
Keep all combustible materials (fabric, wood, paper, etc) at least 1 meter (39 inches)
away from the fixture. Keep flammable materials well away from the fixture.
•
Do not illuminate surfaces within 1 meter (39 inches) of the fixture.
•
Nexera fixtures are convection cooled. Provide a minimum clearance of 0.1 meter (4
inches) around all air vents.
•
The exterior of the fixture can reach temperatures up to 177ºC (350ºF). Allow the fixture
to cool before handling.
•
Do not modify the fixture or install any parts other than genuine Wybron replacement
parts.
•
Do not operate the fixture if the ambient temperature exceeds 40º C (104ºF).
To protect yourself and others from injury due to falls:
•
When suspending the fixture above ground level, verify that the structure can hold at
least 10 times the weight of all installed devices.
•
Use a secondary safety cable when mounting this fixture.
•
Verify that all external accessories and rigging hardware are securely fastened and use
an approved means of secondary attachment such as a safety cable.
•
Always hang the Nexera fixture with the front accessory retaining clip in the locked
position.
•
Block access below the work area whenever installing or removing the fixture.
Summary of Contents for NEXERA 2560
Page 1: ...Color Mixing Luminaire ...
