800.255.3126 | wyeastmedical.com
51928 R03 Vista Non-Powered Stand Aid
Operator’s Manual
Page 10 of 17
VISTA
Operator’s Manual
OPERATING THE VISTA NON-POWERED STAND AID:
1. ENSURE patient is able to sit in an upright posture and the Vista is able to be positioned in front of
the patient as shown (Fig. 3).
2. Move the SEATS out and OPEN the LEGS of the Vista to an appropriate width to maneuver the Vista
around a chair or wheelchair (Fig. 3).
3. Move the Vista toward patient until their feet are completely supported by the footrest and their legs
are in a position as close to 90 degrees as possible (Fig. 4).
4. LOCK the rear WHEELS.
Figure 3
Figure 4
5. Move shin guard forward to rest against the patients shins. Lock Cam Lever.
6. Adjust the shin guard until it rests 2 or more inches below the patients knees (patellae). This prevents
the patient’s kneecaps being pushed upward when they stand up.
7. Instruct the patient to grab the handle bar.
8. CHECK the patients’ body alignment prior to having them stand. Ensuring that the patient and the
Vista are in alignment with each other will help alleviate any feelings of being off balance during the
transfer.
90°
