9
Inspection & Setup
Inspection & Setup
Spray Trailers
The
Spray Wyng II boom can be mounted on a variety of
trailers including the VersaTrail, 1,600 gallon, the 1,000
gallon tandem axle, the 1,000 gallon single axle.
The VersaTrail, 1,600 and 1,000 gallon tandem/single axle
are delivered set up and should need no further assembly.
The sprayer was tested at the factory, but the sprayer
should be checked for any damage during shipment. It
is important to check the lug bolts upon delivery and after
100 hours of operation. Tighten as necessary.
Attach the trailer tongue to the tractor drawbar. The sprayer
should be leveled by adjusting the hitch in the trailer tongue.
Lower the jack, unpin the hitch from the tongue and raise
or lower the tongue as needed to level the sprayer. Pin the
hitch in the appropriate holes.
Figure A1
Check and Tighten Lug Bolts
All Spray Trailers:
The
Spray Wyng II Boom requires only two tractor remote
circuits. One circuit powers the pump and while the other
circuit powers all the boom functions. The Spray Wyng II,
from the factory, is set up to operate on open-center and
closed-center hydraulic systems without any modifications.
Enhanced performance is available on closed-center sys
-
tems with a field modification. Call Wylie Customer Service
for details. (888-788-7753).
Transport Lights
The Spray Wyng II is equipped with red and amber
transport lights that function in the same way as the tractor’s
flashing lights. Make sure the sprayers lights are plugged
in and operating before transporting the sprayer on any
public road.
Figure A2
Adjust Hitch To Level Sprayer
Figure A3
Hydraulic Hoses
Hitch Pins
< Electrical
Connection
< Pump Hyd.
Hoses
< Lift/Tilt/Fold
Hyd. Hoses
Lift/Tilt/Fold >
Control Cable
Spray >
Control Cable
Figure A4
Transport Lights
Summary of Contents for Spray Wyng II
Page 4: ... ...
