26
Outer Wing Boom Rest
The outer wing boom rest can be adjusted laterally to align
with the boom. Loosen the adjustment bolts and slide the
rest to align with the boom.
VersaTrail/Single Axle Hitch Adjustment
The spray trailers feature an adjustable hitch to maintain a
level trailer and boom with different tractor drawbar heights.
With the trailer pinned to the tractor drawbar and the park
-
ing jack supporting the tongue, remove the two hitch pins.
Level the trailer with the jack, then insert and lock the pins.
Figure D13
Adjust Hitch To Level Trailer
Maintenance
Figure D12
Outer Wing Boom Rest
Adjustment Slot >
Outer Boom Rest >
Adjusting Spray Wyng II Boom
The All-Directional suspension will keep the boom level
in most situations. If the boom is not level when unfolded,
check it verify that mud or some other object is not weighing
down one end of the boom or that the tilt cylinders are not
totally extended. The Spray Wyng II is equipped with a set
of springs at the bottom of the pivot frame.
If the boom is not level, loosen the jam nut on both sets
of springs. “Tighten” the adjustment nut on the side of the
boom that is higher. Count the number of turns so that the
adjustment nut on the opposite side can be “loosened” the
same number of turns. The springs should maintain the
same tension. Manually raise and lower the end of boom
two times and let the boom settle. Check to see if the boom
is level. Adjust further if needed. Tighten the jam nuts when
the boom is level.
Figure D11
Boom Adjustment Springs
< Pivot Frame
< Springs
< Jam Nut
Center Section
Summary of Contents for Spray Wyng II
Page 4: ... ...
