background image

Copyright © 2020 WyreStorm Technologies | 

wyrestorm.com

EX-100-H2-PRO v1 Quickstart Guide | 200227

UK: +44 (0) 1793 230 343 | ROW: 844.280.WYRE (9973) 

support@wyrestorm.com

4 of 4

Note: 

WyreStorm reserves the right to change product specification, appearance or dimensions of this product at any time without prior notice.

Specifications

Warranty Information

WyreStorm Technologies LLC warrants that its products to be free from defects in material and workmanship under normal use for a 
period of five (5) years from the date of purchase. Refer to the Product Warranty page on 

wyrestorm.com

 for more details on our limited 

product warranty.

Audio and Video

Transmitter

Receiver

Inputs

1x HDMI In: 19-pin type A
1x Audio In: 3.5mm (1/8in) TRS Stereo

1x HDBT In: 8-pin RJ-45 Female
1x Audio In: 3.5mm (1/8in) TRS Stereo

Outputs

1x HDBT Out: 8-pin RJ-45 Female
1x Audio Out: 3.5mm (1/8in) TRS Stereo

1x HDMI Out: 19-pin type A
1x Audio Out: 3.5mm (1/8in) TRS Stereo

Output Video Encoding

HDBaseT Class C

Encoding Data Rate

10.2Gbps

End to End Latency

10μs (micro seconds)

Audio Formats

2ch Analog/PCM | Multichannel: LPCM up to DTS-X and Dolby Atmos

Video Resolutions (Max)

Video Resolution

HDMI

Cat6

Cat6a/7

1920x1080p @120Hz 12bit

70m/230ft

70m/230ft

100m/328ft

1920x1080p @60Hz 12bit

15m/49ft

100m/328ft

100m/328ft

3840x2160p @24Hz 10bit 4:2:0 HDR

15m/49ft

100m/328ft

100m/328ft

3840x2160p @60Hz 8bit 4:4:4

7m/23ft

70m/230ft

100m/328ft

3840x2160p @60Hz 10bit 4:2:0 HDR

5m/16ft

70m/230ft

100m/328ft

3840x2160p @60Hz 12bit 4:2:2 HDR

5m/16ft

70m/230ft

100m/328ft

Note: WyreStorm recommends the use of shielded category cable to minimize signal noise and interference.

Supported Standards

DCI | RGB | HDR | HDR10 | Dolby Vision up to 30Hz | HLG | BT.2020 | BT.2100

Maximum Pixel Clock

HDMI: 600MHz | HDBaseT: 340MHz

Communication and Control
HDMI

HDMI | HDCP 2.2 | EDID | CEC Pass-through | DVI/D supported with adapter (not included) | DP++

HDBaseT

HDMI | HDCP 2.2 | EDID | Audio | 1-way PoH (TX powers RX) | Bidirectional IR/RS-232/Ethernet | CEC

Ethernet

1x Ethernet: 8-pin RJ-45 Female | Bidirectional over HDBaseT

IR

1x IR RX: 3.5mm (1/8in) TRS Stereo | 1x IR TX: 3.5mm (1/8in) TS Mono (Transmitter and Receiver)

RS-232

1x RS-232: 3-pin Phoenix (Transmitter and Receiver)

USB

1x Type B (host) | 4x Type A (device) (Transmitter and Receiver)
USB direction must be set using switch on both transmitter and receiver
USB hub compatible | Maximum: 7 devices, 23 endpoints
Maximum uplink speed: 190Mbps

Power
Power Supply

12V DC 3A

Max Power Consumption

8.88W

Environmental
Operating Temperature

32°F ~ 113°F (0°C ~ 45°C) | 10% ~ 90%, non-condensing

Storage Temperature

-4°F to ~ 158°F (-20°C ~ +70°C) | 10% ~ 90%, non-condensing

Maximum BTU

30.30 BTU/hr

Dimensions and Weight
Rack Units | Wall Box

<1U

Height With | Without Feet

21mm/0.83in

Width With | Without Brackets

195mm/7.68in

Depth With | Without Handles

94.8mm/3.74in

Weight

0.36kg/0.79lbs

Regulatory
Safety and Emission

CE | FCC  | RCM | EAC | RoHS

Summary of Contents for EX-100-H2-PRO

Page 1: ... 2 0 Host USB Flash Drive Short Throw Projector Hearing Induction Loop 12 DC 2A Power Supply 12 DC 2A Power Supply HDMI Analog Audio RS 232 Interactive Whiteboard RS 232 from Control System KEY Wireless Router IMPORTANT Installation Requirements Visit the product page to download the latest firmware document versions additional documentation and configuration tools Read through the Wiring and Conn...

Page 2: ... ensure that most IR coding formats are transmitted and received Other 3rd party emitters and receivers can be used however these devices must operate in the same manner as the WyreStorm devices Due to differences in IR across 3rd party control systems their IR ports should never be connected directly to a WyreStorm system as an incompatibility may exist WyreStorm offers a cable that compensates f...

Page 3: ...ss through position Set the switch to Pass Through for normal RS 232 operation This is the default setting Set the switch to Update when updating firmware Troubleshooting No or Poor Quality Picture snow or noisy image Verify that power is being supplied to the transmitter and receiver Verify that the HDBaseT cable is properly terminated following EIA568B standard Verify that the output resolution ...

Page 4: ... 328ft 100m 328ft 3840x2160p 60Hz 8bit 4 4 4 7m 23ft 70m 230ft 100m 328ft 3840x2160p 60Hz 10bit 4 2 0 HDR 5m 16ft 70m 230ft 100m 328ft 3840x2160p 60Hz 12bit 4 2 2 HDR 5m 16ft 70m 230ft 100m 328ft Note WyreStorm recommends the use of shielded category cable to minimize signal noise and interference Supported Standards DCI RGB HDR HDR10 Dolby Vision up to 30Hz HLG BT 2020 BT 2100 Maximum Pixel Clock...

Reviews: