15
Model:
DVD-319 Bare Bone
Controller card
ROM or hard drive
CD/DVD writer
Wytron
USB
interface
Note:
1.
Please be noted that all the devices in the case, including
the DVD-319 controller cards, CD/DVD-ROM and
CD/DVD writer, must be connected with 4-pin power
cable which holds 12V (in yellow color), 5V (in red color)
and two black ground wires. Power cable only with 5V
(red wire) is not enough for the duplicating controller card.
2.
Please set two devices as master mode in each channel.
If the ROM and hard drive are both required in special
status, please replace the original cable with a new one
which can chain both ROM and hard drive on same
channel. In this case, please set hard drive to master and
slave to ROM.
3.
Be noted the USB interface is a standard device when
you purchase the DVD-319 bare bone (Wytron two-bay
chassis).
Summary of Contents for CD-398
Page 50: ...50 7 Circuit drawing DVD 688 Controller Card LCD CONTROL HDD DVD ROM POWER ...
Page 51: ...51 DVD 668 Controller Card LCD CONTROL HDD CD DVD ROM POWER ...
Page 52: ...52 CD 398 DVD 399 Controller card LCD CONTROL COM2 COM1 CD DVD ROM HDD POWER ...
Page 53: ...53 DVD 319 Controller Card LCD CONTROL CD DVD ROM HDD WRITER POWER ...