39
or unstable CD writing in high speed. Under this
circumstance, please lower the writing speed under this
setting to get higher successful rate. On the contrary, lower
value setting will make the writing speed slower and
confuse you as a problematic duplicator. Press MODE to
change the setting and GO to exit.
6.1.25 HD to DVD Write Speed (if HDD installed)
This setting controls the maximum DVD writing speed of
writers when the hard drive is installed in the system.
Default setting is “MAX” which will use the highest DVD
writing speed. Sometimes maximum writing speed will
cause higher failure rate that may be due to poor DVD
quality or unstable DVD writing in high speed. Under this
circumstance, please lower the writing speed under this
setting to get higher successful rate. On the contrary, lower
value setting will make the writing speed slower and
confuse you as a problematic duplicator. Press MODE to
change the setting and GO to exit.
6.1.26 Grip before accept
When the option of “Autoloader” function is set to
“extended” or “extend2”, the setting of “Grip before accept”
must set to “Yes” correspondently which will ask the
autoloader do the index repositioning during power booting
stage. If with other setting in “Autoloader”, please choose
“No” in this function.
Summary of Contents for CD-398
Page 50: ...50 7 Circuit drawing DVD 688 Controller Card LCD CONTROL HDD DVD ROM POWER ...
Page 51: ...51 DVD 668 Controller Card LCD CONTROL HDD CD DVD ROM POWER ...
Page 52: ...52 CD 398 DVD 399 Controller card LCD CONTROL COM2 COM1 CD DVD ROM HDD POWER ...
Page 53: ...53 DVD 319 Controller Card LCD CONTROL CD DVD ROM HDD WRITER POWER ...