Wyze Cam Outdoor
Base Station
Base Station Power Adapter
Base Station Ethernet Cable
Camera Charging USB Cable
Quick Start Guide
Screw Assembly
x1
x1
x1
x1
x1
x1
x1
IN THE BOX
Power Adapter
Camera Charging
USB Cable
Ethernet Cable
MicroSD Slot
(MicroSD card not
included)
2
SYNC Button
1
LAN Port
6
Power Input
5
USB Charging port
4
Reset
3
Status Light
7
1
2
Micro SD
SYNC
RIGHT
Power
LAN
5
6
BACK
RESET
3
4
LEFT
7
TOP SURFACE
SETUP
3
Follow the Wyze app to set up the camera.
4
Follow the instructions in the Wyze app to
mount the camera.
Screw Assembly
V2.0
WVOD1B1-KSZP01 V2.0
背面
WVOD1B1-KSZP01 V2.0
正面
WVOD1B1-KSZP01
100×55
105g
无光铜
（成品）
Microphone
3
Removable Magnetic
Mounting Base
4
Lens
2
Light Sensor
1
MicroSD Slot
(MicroSD card not
included)
8
SYNC Button
7
Mounting Hole
9
On/Off Switch
USB Charging Port
5
Status Light
6
1
2
3
4
FRONT
5
6
OPEN
BACK
BOTTOM
Removable Magnetic
Mounting Base
SYNC
Micro SD
7
8
9
Wall Mounting
Ceiling Mounting
LIGHT INDICATIONS
Flashing red light
The device is charging
Solid red light
The device is fully charged
No indicator light
The device is powered off or sleeping
FCC Warning:
Any changes or modifications not expressly approved
by the party responsible for compliance could void the
user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
FCC Radiation Exposure
Statement:
ISEDC RSS warning :
CONTAINS A LITHIUM ION
BATTERY
Do not improperly dispose or discard. Lithium-ion
batteries should be recycled. For information on
how you can recycle the product at no cost, visit
wyze.com/recycle.
ISEDC Radiation Exposure
Statement:
This equipment complies with ISEDC RF radiation
exposure limits set forth for an uncontrolled
environment. This transmitter must not be
co-located or operating in conjunction with any other
antenna or transmitter.
This equipment should be installed and operated
with minimum distance 20cm between the radiator &
your body.
Cet appareil est conforme aux limites d'exposition de
rayonnement RF ISEDC établies pour un
environnement non contrôlé.
Cet émetteur ne doit pas être co-implanté ou fonctionner
en conjonction avec toute autre antenne ou transmetteur.
Cet équipement doit être installé et utilisé avec une
distance minimale de 20cm entre le radiateur & votre corps.
Any changes or modifications not expressly approved
1
Follow the Wyze app to set up the base station
.
2
Download the Wyze app and create an account.
①
③
②
QUICK START GUIDE
CAM
OUTDOOR
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment. This equipment should be installed and
operated with minimum distance 20cm between the
radiator & your body.
This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
④
①
②
③
Base Station
Solid yellow light
The device is powered on and initializing
Flashing yellow & blue lights
The device is pairing with the camera
Solid blue light
The device is working properly
Flashing blue light
The device is connecting to the network
Wyze Cam Outdoor
Solid yellow light
The device is powered on and initializing
Flashing yellow & blue lights
The device is pairing with the base station
Solid blue light
The device is working properly
Flashing blue light
The device is connecting to the network
1. Prolonged direct sunlight can heat the inside of
your camera past its maximum operating
temperature of 122°F (50°C). Avoid directly
sunlight where possible and only use your camera
in environments within its operating temperature
range: -4° to 122°F (-20° to 50°C).
2. To charge your camera, plug the included micro
USB cable into the USB port on your base station
and connect it to your camera. Or use a power
adapter and cable that will provide 5V/2A power.
Precautions:
Troubleshooting & FAQs
support.wyze.com
Join Our Community
https://wyze.com/community
Contact Us
https://support.wyzecam.com/
1-844-WYZECAM
Tutorial Videos
www.youtube.com/wyzelabs
NEED HELP?
This device complies with ISEDC licence-exempt
RSS standard (s). Operation is subject to the
following two conditions: (1) this device may not
cause interference, and (2) this device must accept
any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'ISEDC
applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions
suivantes:
(1) l'appareil ne doit pas produire d'interférence, et
(2) l'appareil doit accepter tout interférence
radioélectrique subi, même si l'interférence est
susceptible d'en compromettre le fonctionnement.
by the party responsible for compliance could void
the user's authority to operate the equipment.
Tous changements ou modifications non
expressement approuvé par la partie responsable de
la comformité peut annuler l'authorite de l'utilisateur
a opérer l'équipement.
