PRO2000_DR/AB-6/98
Tampa, FL33618
Technical Support: 800 832 4003
™
®
24
Troubleshooting
• Check that the slide switch under the
SET UP flip door is set to RUN1 or
RUN2.
• Check that the battery indicator on the
Remote Control turns on when you
press ARM. Replace the battery and
reinstall the Remote if necessary.
• Make sure all zones are closed and
the Motion Detector is not triggered.
If the system does not arm.
If a zone indicator flashes slowly.
One of the sensors/motion detectors has
not reported in, in the last 4 hours.
Check that the battery in the sensor/
motion detector is good.
If you need to arm the system and want
to ignore a sensor/motion detector which
is not functioning:
1. Press ARM on the Remote control.
You hear a repetitive trouble alarm to
alert you that there is a problem.
2. While the trouble alarm is sounding,
press BYPASS on the Console. The
zone indicator flashes rapidly.
Then press ARM on the Remote Control.
The problem zone will be Bypassed but
all other zones are armed.
Note: if you bypass an open window and
arm the system (as described above)
and later close the window, that zone will
now arm and its zone light will stop
flashing.
The BYPASS button was pressed to arm
the system while a sensor/motion
detector was reporting a problem.
If a zone indicator flashes rapidly.
SOLUTION
PROBLEM
