X-Driven DRS1100, Installation And Operation Manual

How to Change the Setting

1

2
3

4

5

6

1

This is a part to set 
resolution. Default:
VGA

*Resolution

QVGA

(320X240)

VGA

(640x480)

MEGA

(1280X960)

Low

High

2

Recording quality is set.
Default : Standard
(Rough, Low, Standard, 
High, Fine)

3

Recording Speed (Recorded frames per 
second) is set. Default: 5 (1~8)

4

Threshold of Impact Sensor is set. 
Default : 0.6G(0.1~1.5G) 
If the threshold value is too high, the 
sensor is too dull to sense an occur-
rence of an event, when the threshold 
is too low, it becomes too sensitive so 
it will detect even slight shocks that 
do not need to be detected. Thus, 
an appropriate value should be set in 
consideration of a user’s vehicle and 
the condition of road while driving. 
X-axis : Front-Back movement
Y-axis : Left-Right movement
Z-axis : Up-Down movement

* Note

As resolution, recording quality, and recording speed is set higher, 
it takes more of the SD memory card storage.

UbONE

X-Driven

11

7

5

The recording time interval between 
pre-event and post-event is set to the 
unit of seconds.
Default – Pre-accident : 10 (0~10)
             Post-accident : 10 (5~30)

6

Audio recording function is set.
Default: On

8

Set the time (zone) (in which the 
device) is used.

8

7

Alarm function is set. (Default : On)