X-Driven DRS1100, Installation And Operation Manual

UbONE

X-Driven

6

Installation Instructions

* Note

When a radio antenna is a glass-attaching type, it should 
be attached with a distance from the GPS part as an 
antenna can affect the GPS reception. 

While pressing both left and right buttons on the side of 
the body, rotate the camera lens to adjust its angle. The 
line on the button should be set to a horizontal position 
and be parallel to the road surface so that the camera lens 
faces the front center of the windshield.

Insert the power cable into the power terminal on 
the camera body, and ensure you use the power 
cable enclosed in the product package.

After connecting the power cable into the cigarette 
lighter jack of the vehicle, turn the ignition, and the 
device will also turn on. Please check if the REC and 
GPS LED are lighted on.

Horizontal

Horizontal

When GPS receiver is in the horizontal 
position, reception rate is better. 

* Note

After the initial operation begins, do not turn off the power for 2 – 3 minutes until 
a continuous beeping sound is heard. This indicates that the SD card is formatted 
and the PC installation program is being copied. If the power is turned off during 
this operation, it may cause a malfunction. In this case, please contact the manu-
facturer or the store where you purchased the product. 
Initial GPS reception time may vary depending on location.

Installing the device to the windshield of a vehicle