X – 60 Instructions Version 1.0
Page 10
19)
Remove the three bolts that go through the transmission
and hold the motor plate on. Save these bolts for reuse
in A-12; the plate will not be needed.
20)
Two flat head screws hold the body mounts on from
the front of the tower. You may remove them and
the mounts if you wish, or just loosen and twist the
mounts out of the way for step 21.
21)
From the top, put your wrench down between the body mounts and remove the
two cap head screws that secure the transmission to the shock tower. You
should now be able to remove the transmission from the truck. Save the screws
for re-use in D-2.
22)
Remove the bottom bolt that holds together the two halves of the transmission
case and carefully separate the case halves. Save this bolt for re-use in A-10.
