X – 60 Instructions Version 1.0
Page 31
D7)
Use the four 4-40 lock nuts to
install the battery strap. There is
room for the wires on your LiPo
pack on the left side of the chassis.
If you will use NiMh cells, you need
part # 1224, a CF strap that fits
just as the LiPo strap fits. Make up
a 4 + 2 pack, and place the 4 cells
in the rear and the two in front. You
can shim the 2 cells anyplace in
their space for weight distribution.
D8)
If you are using LiPo, install the E.S.C. (long arrow) in the center of the
chassis just ahead of the battery slot. If your receiver will fit in front of the
E.S.C., we suggest you place it in the center too. We have supplied two
antenna mounts (short arrows) so you may place the receiver on either
side or run the wire on the convenient side. Run the wire down through
the tiny hole at the side of the mount so the wire sticks out the bottom of
the truck. Then push the wire back up through the center of the hole and
into the tube. When the antenna wire is properly in the tube, push the
tube into the chassis.. Here, Chris has an interesting antenna “loop” going
from one side of the truck to the other. Cool!!!
