630140_1
XFIRE_1200_GB_Manual_R
‐
emotion
13.0
Fitting the Flue Restrictor:
If your flueing configuration requires that you fit a flue restrictor
(
see graphs in section 12.5, 12.6 & 12.7 of this manual to find out
if your configuration requires a flue restrictor
), follow the
instructions below.
First, prepare the Flue Restrictor by removing and discarding the
inner rings to achieve either 60%, 70% or 80% restriction as
required and hand bending the five tabs 90°
Remove the firebox glass (if
fitted), and using a Phillips /
Pozi Drive screwdriver
remove the two screws
located inside the firebox as
shown.
Once the two screws are removed the baffle will
be free to slide down and out as pictured. Ensure
the firebox paint is not scratched and that the
baffle is not damaged
Fit the flue restrictor by pushing it up into the flue
with the tabs facing downwards as shown. Push
it up into the flue until the tabs no longer
protrude into the firebox and it is securely
placed. If the restrictor is loose or will not stay in
position manipulate the five tabs to suit.
Once the restrictor is in place, replace the baffle
taking care not to damage or scrape the paint,
and replace the two screws.
