7
UNFOLDING THE FRAME
Unclip the linking interlock (a). Unfold the pram by lifting its handle up until the locks (b)
are engaged.
WARNING:
Prior to assembling the baby carriage make sure that folding
gears have been locked.
FOLDING THE FRAME
Detach the carrycot, seat unit or car seat from the frame. Pull the grips on the handle up-
wards (a). Fold the frame holding the handle as shown in the picture (b).
ASSEMBLY AND DISASSEMBLY OF REAR WHEELS
To attach the wheel, press the button in the centre of the wheel and slide the wheel axle
into the mounting socket. Pull on the wheel to check that it is securely attached. In order
to remove the wheel press the button in the centre of the wheel and pull it out of the
mounting socket.
MOUNTING OF THE FRONT WHEEL
In order to mount the wheel, slide it onto the axle until the lock is engaged.
DISMOUNTING OF FRONT WHEEL
In order to take the wheel off, push the button shown on the figure, and pull the wheel off
the axis.
WHEEL BLOCKADE
The stroller is provided with swiveling front wheels. A special button blocks the wheel
swiveling movement. After the button has been pressed, the wheels are blocked straight.
To release the blockade, press the lever.
HANDLE LENGTH REGULATION
Press the button in the middle of the handle and adjust its height by pulling it towards you
to lengthen it or pushing it away from you to shorten it.
WARNING:
Changes in the position
of the handle height should not be made when the stroller is in motion. Otherwise, you
may lose control of the stroller and damage the handle. It may threaten child safety.
BRAKE
To lock the wheels, press the brake lever in its closer part (a). To release the brake, press
the brake lever in its distant part (b).
SHOPPING BASKET INSTALLATION
Fasten the snap fasteners and attach the basket to the chassis as shown in the pictures.
INSTALLING SEAT UNIT ON THE FRAME
Slide the catches of the stroller seat unit into mounting seats in the frame, until locks are
engaged. The seat unit can be mounted facing front or rear.
DISMOUNTING SEAT UNIT FROM THE FRAME
Push the buttons unlocking catches of seat unit in (a), then pull it out from mounting seats (b).
MOUNTING / REMOVING THE STROLLER HOOD
To mount the basket to the frame, press the plastic basket holders onto the mounting pins,
then wrap the straps around the frame tube and fasten the snap fasteners together.
BACKREST ADJUSTMENT
Pick up the tie and put up the backrest in required position.
FOOTREST ADJUSTMENT
Press the buttons on both sides of footrest and adjust it to the required position.
INCREASING THE HOOD INCLINATION ANGLE
The hood may be expanded by an additional part. In order to do this, undo the zipper
between the upper and lower part of the hood.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
ENGLISH
