4
- 19 -
- 18 -
1.6
Maintenance and cleaning
USE ONLY NEUTRAL SOAP AND WATER FOR CLEANING AND
COMPRESSED AIR AS A DRYING AID.
Scratch Resistant Racing Visor
The visor of this helmet with a flat external surface comes with
adjustable hooks to mount extra tear-off visors using the same
system used by professional riders.
To mount the extra tear-off visors see the instructions in the box.
Important!
- The combination between tear-off and helmet visors can slight-
ly reduce light transmittance and increase light diffusion. For
this reason use of the two visors together is not approved.
- Tear-off visors use is only recommended for track competi-
tions. Do not use them for normal road use.
- Do not apply more than one tear-off film at a time since optical
distortion will occur causing reduced visibility.
- Damaged or scratched visors and tear-off visors must not be
used and should be replaced.
2. Racing Comfort - Inner comfort padding
2.1
Disassembly of the cheek pads (fig. 4)
2.1.1 Pull up the visor and undo the chin strap.
2.1.2 Hold the top of the cheek padding and pull it inwards to
unhook the first button.
2.1.3 Hold the padding by the top of the chin guard and pull
inwards to unhook the second button.
2.1.4 Hold then the bottom padding of the chin guard and pull it
inwards to unhook the third button.
2.1.5 Hold the cheek padding towards the nape of the neck and
pull inwards to unhook the fourth button.
2.1.6 Hold the cheek padding and pull it upwards to pull out the
side flap from the shell sealing edge and detach the cheek
pad from the helmet.
2.1.7 Repeat step 2.1.2 on the other side of the helmet.
2.2
Disassembly of the liner (some versions only - fig. 5)
2.2.1 Take hold of the back rest by the right hand corner and
pull upwards to unhook the first button. Then proceed by
pulling the centre section on the left corner of the back
rest to unhook the second and third button.
2.2.2 Take hold of the side front section of the liner and gently
pull it upwards to unhook the first hook. Then move
towards the centre and the other front edge to unhook the
