Power supply and charge :
There are three types of supplying power: battery, adaptor, USB cable.
The X-Map 4000 & 5000 use the Li-battery to supply it’s self with power when it’s not
connected with adaptor.
The mark [
] on the up right of interface indicate the current electric battery life time.
The X-Map uses the external power when it is connected with the ATV, Side by Side,
motorcycle, car or Jet Ski.
The X-Map uses the USB cable to supply power when the X-Map connects to the PC.
【
Remark
】
This X-Map adopt built-in, unchangeable Lithium battery. At normal condition (if
the back light is not so bright), the actual battery lifetime can be different because of the
different ways of using the X-Map. Some function (audio playing, video playing, bright back
light) will consume a large power, which will reduce the battery lifetime.
【
Note
】
This X-Map adopts built-in, unchangeable Lithium battery. In order to
avoid fire and burning, please do not poke, bump or take it apart or throw it into
fire or other dangerous substance for electronics or lithium!
Charger Installation:
1.
Vehicle charger uses 12V auto standard voltage. Home Mini USB charger
voltage from 100V—240V, output voltage is +5V.
2.
For vehicle charger, connect the X-Map in to the bracket/mount and the power
cable to the power supply jack. (The other end cigar lighter connects to the cigar
lighter plug of the vehicle.)
3.
For home Mini USB charger, connect the Mini USB cable to the power supply
Mini USB connector of the X-Map 4000 or 5000, the input end to the
computer.
4.
The X-Map will stay in working status after shutting down the engine of the
vehicle, so when you do not use the X-Map, please power off the system and
take out the supply cable for longer battery life power time.
5.
After start the vehicle, put into the vehicle charger out to avoid the damage to
your X-Map during the starting moment.
【
Note
】
Do not connect directly to atv, car, motor or jet ski battery.
Use the car charger to supply power
1. Connect the DC part with the motorcycle, the red line is connected with ignition
switch and the black line is connected with the negative pole, when you turn on the
motorcycle, the GPS navigator will turn on automatically.
2. The other part connect to the power socket, it supplies power while charging.
Power Saving
Power interface contains battery capacity check, screen brightness adjust, LCD off time
setting and automatic power off time setting.
You can adjust the following sound functions.
-‐
Screen lightness, to adjust the brightness of the screen.
-‐
Battery capacity, to check the current battery capacity used.
-‐
LCD Shut off time, to set the backlight time when not in use to save power.
-‐
Power off time, to set the shut down time in order to save power.
