EasyTrax Setup and Operation
7
Unpacking and Inspection
After removal, inspect the system for damage. If any damage has occurred during shipping,
immediately contact the transportation company. Do not proceed with installation until the
carrier’s agent has inspected the damage.
Your instrument was packaged in a specially designed carton to assure against damage. If
shipment is necessary, the instrument should be packaged in the original carton along with all
the accessories. If the original carton is not available, contact X-Rite to have a replacement
shipped to you. Refer to the Appendices for information on repacking the system if required.
Packaging Contents:
•
EasyTrax™ scanning system with hold-down magnets and paper stops
•
Power supply (P/N SE30-109) with line cord
•
Ethernet cable
•
Software CD
•
Getting connected instruction
•
Documentation package (manuals, registration form, certificate of calibration)
System Connections
Note:
Please allow
the system to stabilize at room temperature before plugging the power
supply into an AC wall receptacle.
1.
Position the system on the console. Make sure the console is set to no more than a 45° angle.
2.
Plug one end of the Ethernet crossover cable (1) into the Ethernet port on your computer.
For X-Rite turnkey systems, make sure to plug the Ethernet cable into the port labeled “ITX”
on the network card.
3.
Plug the other end of the cable into the Ethernet port (1) on the right side of the system
measurement table.
4.
Plug the input connector from the power supply (2) into the input port located on the right
side of the system measurement table.
5.
Plug the detachable line cord into the power supply and then plug the line cord into the AC
wall receptacle.
Ethernet connection
AC adapter connection
Operational hazard exists if a power supply other than X-Rite SE30-109 is used.
