X-Stream CLEAN MicroBurst XCSAGA-2P, Operation Manual

Required tools: Phillips head screwdriver

Before you begin, open the tank lid (1) and 

remove the nuts and bolts, holsters, and 

nozzles from inside the tank strainer (3). Set 

aside. 

Bring the ComfortStraps™  (5) to the bottom 

of the tank (2). Secure lower strap clips to 

the tank loops near the bottom of the tank. 

Next, slide the  adjustable strap through the 

top tank loop. Continue by sliding the strap 

over and under the buckle fitting. Lightly tug at 

the strap to make sure it’s secure. Repeat on  

other side.

Place the top wand holster (4) on the molded 

holster bracket on the tank. While holding 

the holster, place  nut on one side of the 

hexagonal slots and screw the bolt through 

the other side until it fastens into the nut. 

Repeat for other slot and bottom holster.

Take the spray gun (8) and attach it to the 

threaded fitting on the end of the hose (7). 

Tighten the fitting to ensure the gasket 

properly seals the connection.

If spraying with the stainless-steel spray 

wand (6), pull back on the collar of the 

quick-connect fitting on the spray gun. Insert 

the male wand fitting into the female spray 

gun fitting and push the collar back into its 

original position. Nozzles can be attached 

with the same process.

Snap the spray wand into the wand holster 

and place any unused nozzles into their slot 

until ready to spray.

A) 

B) 

C) 

E)

F)

G)

STEP 1.

ASSEMBLING YOUR NEW SPRAYER

D)

Copyright © WESSOL, LLC

10