Page25
small tab that bends outward.
2) Reach inside the front of the connector with a dental pick or jeweler
’s screwdriver and
bend the tab in then pull the metal pin out the back of the connector.
3) Reinsert the new wires into the white connectors.
How To Replace A Controller
1) Remove Main Fuse.
2) Gain access to where the Controller is located.
3) Place the New Controller alongside the Original Controller.
4) Disconnect and re-connect One (1) Connector at a time. We recommend starting with
the Largest Connector and working down to the Smallest Connector. This will avoid
confusing the connectors.
5) With the Original Controller free of all wire connectors remove from frame.
6) Install the New Controller in its place with the original screws if equipped or with Double
Sided Tape.
7) Install Main Fuse.
8) With Drive Wheel Not touching Any surface test run the motor and check accessories to
confirm that they are functioning correctly.
9) Re-assemble and test ride. This is also a good time to perform a full check of the
brakes, tire air pressure, etc.
Do this for all the white connectors. Remove the old controller from the scooter and install
the new controller.
How To Test Motor Direct To Battery
** ATTENTION: Prop the scooter up so that the rear wheel is NOT touching the ground. In
this test the drive wheel will run Full Speed.
1) Access the Battery and Controller compartment.