7
2.1" " is the start/stop key:
when the power is on, press this key at any time to start the running of the walking
machine; in the process of motion, also through this key to stop the running of the walking machine, and reset zero.
Press this key instrument to enter dormant state after shutdown; press any key to wake up the instrument in dormant
state.
2.2" "," " for the speed plus or minus key:
after starting for the speed adjustment, its adjustment amplitude
of 0.1 km / time, when holding down for more than 2 seconds automatically continue to increase or decrease 0.1
km / time.
3. Actions during movement:
3.1 Pressing the " "button will reduce the speed of the walker.
3.2 Pressing the " "button increases the speed of the walker.
3.3 Press the " "button to slow down to stop running.
3.4 Remote control matching instructions
Turn on the power switch, long press the " "button of the remote control when the screen shows "CHE" time ",
release the button when you hear the" beep "sound, and press the" " button to start the treadmill; if there is no
match at a time, please press the above steps to try several times.
4. energy saving mode:
No operating machine enters energy saving mode within 10 minutes of standby mode, the display screen has no
display, press any button to exit to standby mode.
V. Maintenance guidelines
Proper maintenance can always keep your walking machine in the best condition; wrong maintenance can hurt or
shorten the service life of the walking machine.
Warning: before cleaning or maintaining the product, be sure to unplug the walker!
1. Regular dust removal to keep components clean,
2. After each use of walking machine, wipe clean instrument and other parts of sweat stains and sundries with clean
towel or cloth, please be careful not to splash water on electrical components and under running belt.
3. Please put your walkers in a clean, dry environment, make sure the power is turned off and the plug has been
unplugged.
4. To facilitate movement, the walking machine is equipped with wheels. Make sure to disconnect the power and fold
the fuselage before moving.
5. Check all machine parts frequently. Damaged parts must be replaced immediately.
6, In order to better maintain and extend the life of the walking machine, it is recommended that after 30 minutes of
continuous use, let the walking machine rest for 10 minutes.
7. The running belt has been adjusted when it is out of the factory, but after use, the running belt will be stretched,
which will deviate from the center position and cause friction edge strip and rear cover damage. It is normal that the
running belt is forced to stretch during use. After a period of time, if you are using the walking machine, the running
belt slips or is not smooth, you can adjust the tightness of the running belt to improve.
A. Run belt elastic adjustment If the running belt is too loose, insert the randomly presented hexagonal wrench
into the adjusting hole of the left foot guard of the walking machine, rotate 1/4 laps clockwise, and then rotate 1/4 laps
clockwise to the right foot. Note that the left and right should be adjusted synchronously. If the running belt is too tight,
the left and right synchronization counterclockwise adjustment.
Note: the running belt cannot be adjusted too tightly. This will break the running belt, increase the pressure of the front
/ rear roller, bring harm to the roller bearing, produce abnormal sound or other problems, just adjust to the running
belt without skidding is the most appropriate.