- 10 -
Install/Remove Hot Air Attachment
1. Turn the power off to the unit and unplug it from the power source.
2. Allow the hot air gun and attachment to reach room temperature
before proceeding.
3. Do not use excessive force when installing/removing hot air
attachments. Loosen the screw and nut from the attachment
by holding the nut with a pair of pliers and turning the screw
counterclockwise.
4. Slide the attachment off of the metallic shaft of the hot air gun.
5. Repeat in the reverse order for installation.
Do not overtighten the
screen and nut on the hot air gun.
Troubleshooting Guide
Nothing appears to happen
when turning on the unit
•
Check to ensure that the unit is plugged
in
•
Make sure that the plug used is
grounded
•
Check for a blown fuse on the main
power input and replace it if needed
•
Make sure the main breaker in the
house is not tripped
•
Contact the manufacturer
Soldering Iron not heating.
•
Ensure unit is plugged into a grounded
outlet
•
Ensure that the proper power switch is
on
•
Ensure the soldering iron is securely
attached to the unit
•
Replace the heating element
•
Contact the manufacturer
Hot air gun not getting hot
•
Ensure the unit is plugged into a
grounded outlet
•
Ensure the correct power switch is
turned on
•
Replace the heating element
•
Contact the manufacturer
Summary of Contents for 8080
Page 1: ...X TRONIC USA X Tronic Model 8080 Instructions...
Page 2: ......
