X-Tronic Platinum Edition 2000-XTS, Instruction & Tips

- 7 -

PROCEDURE TO ULTRASONICALLY CLEAN YOUR OBJECT

1.  Turn the unit Off for 1 Second and back on to reset the Temperature & Time 

to 0.

2.  Turn the Time Set Knob to the desired amount of minutes you would like 

for cleaning your object(s). Note that most all objects will be thoroughly 

cleaned in 15 to 30 minutes.

3.  Turn the Temperature Knob back to your first selected temperature or 

whatever temperature you are going to clean your object(s) at. Note that 

this will show the temperature in the Temperature Display as you have 

already heated up the solution.

4.  If desired, turn On the Sweep Function (highly recommended) for the entire 

cleaning time. 

Note during cleaning; dO NOT use the degassing Function as it is not 

needed during cleaning. This is why the programming in the ultrasonic unit 

will NOT let the Sweeping Function and the degassing Function to work/

run at the same time.

5.  Set the Cleaning Basket or Wire Rack into the tank.
6.  Put the objects into the basket or hang from the wire rack to clean them.
7.  After the unit has run for the allotted time you set, it will automatically shut 

off. When this happens, all Function Key Indication Lamps (LED’s) will shut 

off but the bottom Main On/Off Switch Lamp. You can now shut the unit 

completely Off by pushing the On/Off Switch and unplugging the unit.

SPECIAL INSTRUCTIONS

When you are cleaning objects that have air pockets in them, you may wish to 

rotate the object you are cleaning a couple of times (under the water/cleaning 

solution) to get these air pockets out before ultrasonic cleaning them.

do not put any object directly on the bottom of the tank to be cleaned – always 

use the cleaning basket, wire rack or place it in a beaker filled with water/cleaning 

solution while the beaker is being held in place by the beaker holder. 

We do NOT recommend placing the lid on the unit during the cleaning process as 

it is not needed during the cleaning process.