5. Press each number key from 0 – 9 as above to find the second digit.
6. Press each number key from 0 – 9 as above to find the third digit. When the third
digit has been found the LED will go off. Don’t forget to write down the code on
the label of the battery compartment.
9) Learning commands
Your UR76E remote has the codes for most TV’s, VCR’s etc. in its code library.
However, if the code for your particular device is not found in the library, you can
learn these codes from your existing remote. Or if you find a code from the tables in
this manual that “almost” matches your device, but a few buttons are missing, you
can learn just those buttons.
1. Point your existing remote at the UR76E remote (front to front) with a distance of
about 2,5 centimetres between the remotes.
2. Press and hold SETUP (2) until the LED indicator lights steadily.
3. Press the mode button (TV, CD, SAT, etc.) that matches the equipment you wish
to learn. The LED (1) blinks once.
4. Press and release the LEARN button (24). The LED (1) blinks once.
5. Press and release the button on the UR76E remote which will learn the function.
The LED blinks once.
6. Press the function key on your
existing
remote that you want to transmit. Hold
the button until the LED on the UR76E remote blinks off shortly.
7. Repeat steps 5 and 6 for each function you want to learn.
8. When you’re finished learning all the keys, press SETUP (2) .
10) Clearing learned commands to free up memory:
To Clear all stored Learned Commands under a Mode
:
You can clear learned commands for each device individually (TV, VCR. Etc.):
1. Press and hold SETUP (2) until the LED indicator light steadily. Release the SETUP
button.
2. Press the desired mode button (TV, VCR, etc.) (4). The LED flashes once.
3. Press and release the LEARN (24) key twice.
4. Press the SETUP (2) key. The LED (1) will turn off after a few seconds.
5. All learned commands entries under that mode are now cleared.
Master Clear - To Clear all stored Learned Commands
(recommended on first
time Learning) :
1. Press and hold SETUP button (2) until the Visible LED (1) remains on
(approximately 2-3 seconds).
2. Release SETUP button.
3. Press and release the Learn key (24) twice. LED (1) will blink off to indicate the
keypress acceptance.
-9-