13) Changing the X10 House Code
The preset house code is A and in the majority of cases it is not necessary to
change this setting except if there is interference from neighbouring X10 systems.
In that case :
1. Press and hold
SETUP (2)
until the LED lights continuously
2. Release the
SETUP (2)
button
3. Use the digit keys to enter the number equivalent to the chosen home code
(1=A, 2=B, ... 16=P).
4. Press the
--/-
(13) to confirm your command. The LED will turn off
Note : The code you have chosen for your remote has to be the same as the one
selected on the Transceiver module TM13 or the security console.
14) Problems and troubleshooting
The remote doesn’t work or looses codes entered
· Confirm with your original remote that the equipment works correctly
· Make sure that you have pressed the corresponding mode key of the equipment
or device that you want to control.
· If the listed code does not work, try the AUTOSEARCH method or enter the next
code of that brand.
· To find the corresponding code for your equipment use the automatic search.
· Check that the batteries respect the polarity of the battery compartment.
· The programming of the remote requires 2 AAA batteries (new). If the remote
looses codes within a few days/weeks the problem can be solved by using 2 new
batteries of the same brand.
· If the LED is lit permanently, it will generally be necessary to replace the
batteries.
Important:
The UR76E must be used only in the way described in this instruction
manual and may not be used for a purpose not intended.
- 12 -