Default Volume Control
SAT box may not be equiped of a volume adjustment function. Nevertheless, the
remote control can command the volume via the TV, even if the last selected mode
was SAT. (No need to repress TV mode key). Just proceed as follow :
1. Press and release the TV Mode button (4) – remote must be in TV mode for this
procedure.
2. Press and hold SETUP (2) button until LED remains on.
3. Release SETUP button.
4. Press and hold the Mute (8) key for approximately 8 seconds. LED will blink and
stay off for the 8 second period then blink once more to indicate volume default
acceptance. LED (1) will remain off.
5. Remote volume default is now set.
5) Programming your TV, VCR , DVD, SAT, CD and CBL
Note : you can dedicate any appliance (TV, DVD,SAT...) to the VCR, DVD, SAT, CD,
CBL and PC keys : you need first to enter the 3 digit code of the appliance you wish
to control (found in the code book). In any case, follow the method below:
1. Press and hold the
SETUP (2)
key until the LED indicator lights continuously.
Release the
SETUP
key.
2. Press and release the mode key (4) of the device you want to control (for
example TV).
3. Make sure your equipment is switched on (for example TV)
4. Enter the 3 digit code (11) from the library table. The LED (1) turns off after the
last digit is entered. If you entered a wrong code the LED blinks for 3 seconds
and then goes off. You have to repeat from step 2.
5. Point the remote in the direction of your TV and press the POWER button (3).
Your device should turn off. Check other functions (for example for a VCR: FF or
REW etc.). If certain functions are not responding this indicates that the entered
code is not the correct one. In that case repeat the above procedure with the
next corresponding code of your brand.
6. Repeat this procedure for the other equipment you want to control (TV, VCR,
DVD, SAT, CD, and CBL)
6) Manual code search
If your equipment (TV, SAT etc....) does not respond, try the other codes for your
brand. If it still doesn’t respond, try the Code Search method.
If you wish to dedicate another appliance to the VCR, DVD, SAT or CD keys you
need first to enter the 3 digit code of an appliance similar to the appliance you want
to control. i.e.: to search for a SAT code first enter the code (found in the code
book) of any SAT as described in § 5. Then follow the steps below :
1. Make sure your equipment is switched on. If not switch it on manually
2. Press and hold
SETUP (2)
until the LED indicator lights steadily. Release
SETUP
-7-