13
12
Setting ALL Volume/Mute Controls to Any
Mode
You can set all modes to “punch-through” to any mode
for Volume/Mute control without needing to change to
that mode by doing the following.
1. Press and hold
SETUP
until the indicator remains on,
then release
SETUP
.
2. Press and hold
MUTE
until the indicator blinks off,
then release the button.
3. Press and release
SELECT
to select the desired
mode (
TV
,
VCR
, etc.) for Volume/Mute control; the
indicator blinks, then stays on.
4. Press and release
MUTE
; the indicator turns off.
Note:
The indicator will blink rapidly for 3 seconds if
the mode you have selected does not have Volume/
Mute control.
5. All other modes will now “punch-through” to your
chosen mode for Volume/Mute control.
Setting Any Mode to Use its Own Volume/
Mute Control
You can set any mode to use only its own Volume/Mute
control.
Note:
If your chosen mode does not have Volume/Mute
functions, then this remote’s
VOLUME
and
MUTE
will
not operate.
1. Press and hold
SETUP
until the indicator remains on,
then release
SETUP
.
2. Press and hold
MUTE
until the indicator blinks off,
then release the button.
3. Press and release
SELECT
to select the desired
mode (
TV
,
VCR
, etc.); the indicator blinks, then
stays on.
4. Press and release
VOLUME-
(down); the indicator
blinks, then stays on.
5. Press and release
MUTE
; the indicator turns off.
6. All modes will now “punch-through” to the
respective modes you have chosen for Volume/
Mute
control.
Setup (cont.)
Programming Combo Device Codes
Some combo (combination) devices (TV/VCR, TV/DVD,
DVD/VCR, etc.) require you to set up 2 different modes
to control both parts of the combo.
For example, if you have a TV/DVD combo, you might
need to set up one code under the
TV
mode to control
the TV and a separate code (under other modes) to
control the DVD.
VCR/DVD/DVR Punch-Through Feature
This remote allows the 6 VCR buttons (
PLAY
,
PAUSE
,
STOP
,
SCAN+
,
SCAN-
, and
REC
) to “punch-through”
(transmit or hand-over) control from any mode pro-
grammed with TV or Cable codes to the last
VCR
,
DVD,
or
DVR
mode used.
For example, if you have 2 DVD, VCR, or DVR devices
programmed into this remote, the last device you used
controls the 6 VCR buttons.
Note:
This feature will not operate if the programmed
TV, SAT or Cable code has its own VCR transport
button control e.g. a TV Combo, SAT/PVR, etc.
Volume/Mute Control and Punch-Through
Feature
Your
remote
allows you to select which device mode
controls
VOLUME
and
MUTE
.
This remote is initially set for all device modes to use
their own Volume/Mute control if present.
If the programmed code does not have Volume/Mute
operation, then
VOLUME
and
MUTE
will “punch-
through” (hand-over) control to the
TV
-mode device
without you needing to change to
TV
mode.
Note:
Any
mode chosen for Volume/Mute control
must
have its
own Volume/Mute function or else
VOLUME
and
MUTE
will not function.
Setup
